Skylink AM-100 AAA+ Desktop Mountable Home Smart Center
- Skylink Rolling Code Technology
- 5 programmable and supervised zones
- Works with up to 10 sensors, 5 control modules and 5 keychain remotes
- Build-in auto dialer with digital dialer function and Ademco contact ID
- User can call in to check system status
Skylink AAA+ Home Smart Center Alarm System offers home and family security for LESS! You’ve seen those ads on TV: someone’s home alone and an intruder tries to force entry. They certainly make the case for home security, but they never tell you the price. That’s because setup, installation and monthly fees for those systems can run into the thousands. Don’t trip that trap! This smart System from Skylink protects you and your family for FAR less. Setup and installation take just minutes, and the
List Price: $ 134.99
Price: $ 102.37
GE 45603 Z-Wave Technology Wireless Lighting Control Fluorescent Light & Appliance Module
- Adds remote on/off control to fluorescent floor and table lights or small appliances like fans
- Space-saving horizontal design plugs into a standard wall receptacle without blocking the second outlet
- One Z-Wave controlled and one Always-On pass-through outlet
- Start with a room or two and add more over time
- Easily create your own lighting control system
WIRELESS LIGHTING MODULE WITH Z-WAVE TECHNOLOGYADDS REMOTE CONTROL & DIMMING CAPABILITY TO STANDARD INCANDESCENT FLOOR & TABLE LIGHTSSPACE-SAVING HORIZONTAL DESIGN PLUGS INTO STANDARD WALL RECEPTACLE WITHOUT BLOCKING SECOND OUTLET1 Z-WAVE CONTROLLED & 1 ALWAYS-ON OUTLETMAXIMUM LOAD OF Z-WAVE OUTLET: 600W INCANDESCENT 1/2 HP MOTORMAXIMUM COMBINED LOAD OF BOTH OUTLETS: 15A 1800W RESISTIVEUPC : 043180456038Shipping Dimensions : 8.25in X 7.50in X 2.50inEstimated Shipping Weight : 0.9319
List Price: $ 54.99
Price: $ 29.95
Good cheap security system,
System will call you if any of the sensors are triggered. You can add multiple different sensors to the system like temperature and water/flood sensors. This a good product to keep an eye on your house. The alarm is very loud. Sensors works through walls and doors with no problems.
Was this review helpful to you?
Not so good,
I had this unit set up with two motion sensors and three water sensors. I received way too many error messages with this unit. First, the two motion sensors were in unheated areas and I would get false low battery warnings every couple of hours whenever the tempature was below 15 degrees outside. There was no way to get around this. Second, I would have to manually set off my water sensors in my basement about once every two or three weeks or the system would not think they are there anymore and give me false sensor error messages every three hours or so. I’m sure in some applications this system works great but it did not work very good at all for me.
Was this review helpful to you?
Over $250 Wasted,
So, I bought the Kit, a number of additional sensors, and even the Repeater/Range Extender.
With everything sitting on a table it works. So I programmed everything and installed it. Everything seemed to work fine. Just a bit sluggish.
After 24 hours I had to reprogram ALL the sensors. After another 24 hours and nothing worked again. And so all I get now is a constant voice alert that my sensors have all failed.
And it won’t let me go into programing mode anymore.
So… Since I threw out all the boxes, and installed everything with double stick tape, It’s not returnable.
Stay away for this product, far away.
Needs a rating of 0, but the selection doesn’t go that low.
On a technical side, I took apart one of the door sensors and it uses the same technology and frequencies as a lot of Chinese technology. IE: “eBay Strobe Triggers”. You can expect a lot of interference with these.
Was this review helpful to you?
Great Appliance Module; Not a Dimmer,
If you’re looking for a z-wave device that will help you improve the reliability of communications with a z-wave lock such as the Kwikset or Schlage locks, this is by far the best device to go with – it works great in this capacity, is very easy to install and connect to your network and has a pretty smart design that keeps you from losing use of an outlet as many plug-in modules tend to. It supports ‘beaming’, unlike some older z-wave devices, which is a must to interface with z-wave locks.
However, as another reviewer noted, this is NOT a dimmer – it’s designed for fluorescent lights, motors, appliances and other loads that will be either on or off and won’t be dimmed. The device reports itself as a “Z-Wave Switch Binary”, not “Z-Wave Switch Multilevel” or “Z-Wave Dimmer Switch” as it would if it was a dimmer.
I’ve used this to turn lights on and off as well as to control the operation of an air filter whose motor didn’t run well at all when plugged up to a dimmer module.
Adding the module to your z-wave network couldn’t be easier – put your controller in Add mode and then tap the button on the front, which also serves as a manual on/off switch for the z-wave controlled outlet.
This module includes 2 outlets – one on each side; one is always on and the other is controlled by z-wave. If you plug it into the top outlet in a 2 outlet block you can still easily plug in a lamp or other device on the other outlet underneath it, so this module can actually give you 3 outlets where you previously had 2, unlike other modules that turn your 2 outlet block into basically just 1 usable outlet.
Was this review helpful to you?
|another in my house of micasaverde,
I travel a LOT. I’ve pretty much converted most of my outlets, my switches,thermometer, locks – everything. It’s all wireless and connected to my Android phone and my iPad. Never once leave town wondering if I left the A/C on. I have schedules set up so my lights (indoor and outdoor) look like I’m at home. This switch works great. I’m a BIG z-wave supporter. Micasaverde is the way to go. Home automation is super easy with it. It pretty much rocks.
Was this review helpful to you?
|Great Addition to the ADT Pulse,
This product is great. It was very easy to add to my ADT Pulse and is very versatile. I bought two of them when they were a little cheaper. I keep one programmed to turn on a table lamp every night just around sunset, I have them both programmed to randomly turn on/off lights when I travel and turn on lights in the event of a general alarm or a fire alarm. The unit has two outlets on it and it only covers one outlet on the wall plate when plugging it in. One outlet is the programmed side and the other is a constant open so plugging it in to your wall gives you three available outlets. All programming is done through the ADT Pulse website and there are a variety of options for days, times, and events for the unit to turn on/off. I can turn the unit on/off through the website, my phone or the push button. Finally, the programming does not just toggle the switch. It recognizes if the unit is on or off so if you turn it on manually at 6:45 and it is set to turn on 7:00, the Pulse will not send a toggle command. It recognizes it is on and there is no change. Nice feature, great product, far more reliable than the store bought power timers.
Was this review helpful to you?
|